Avaya Ethernet Routing Switch Implementation and Maintenance Exam: 3600 Exam
3600 Questions & Answers
Exam Code: 3600
Exam Name: Avaya Ethernet Routing Switch Implementation and Maintenance Exam
Q & A: 134 Q&As
The Ethernet routing switch (ERS) 5000 switches are being upgraded and it appears that a license
is not recognized on the switch.
Which two statements are valid sources of information that will help resolve the license installation?
A. Check for an ‘invalid license fife’ log report
B. Check the record of MSG address changes
C. Use the show license command to get the license installation status
D. Check to see if the MAC address is correct in the license file.
E. Use the show license file command to get the license installation status.
One of the switches in the Ethernet Routing Switch (ERS) stacks files and is replaced.
The auto unit replacement (AUR) is enabled but the stack is not functioning properly.
What is the problem?
A. The switches in the stack are not identical
B. the stack power was left on during the switch replacement.
C. The switches in the stack are not running the same release of software
D. The stack has two switches with Force Stack disabled.
A technician needs to reboot an Ethernet Routing Switch (ERS) 5000 Series switch with a default
configuration. What needs to be done to keep the IP address and stack license?
A. Boot partial-default
B. Boot-default save-license
C. Boot default-save
D. Boot restore-license
A split multi link trunking (SMLT) for switch clustering is being configured.
Which statement is a configuration requirement for the SMLT?
A. CP-limit is configured on edge switch stacks
B. Neighboring edge switch stacks should be connected to each other via DMLT connection to add resilient
paths in the event of an SMLT failure
C. Alternate the primary path of the SMLT connection to load balance the switch core
D. VLANs that are defied on the SMLT are also defined on the MLT that defines the core IST
A customer needs to install a new Ethernet Routing Switch (ERS) 2550T on the 172.16.5.0/24
network, but does not have a console cable available.
Which statement is correct?
A. The switch will first attempt to use BootP to acquire an IP address, and if that fails it will assign IP
address 22.214.171.124/24 to the switch IP.
B. The customer can set the switch to use the temporary address of 192.168.192.168 by pressing the
User Interface button on the front of the ERS 2550T
C. To communicate with an ERS 2550T the IP address must first be set though the console interface.
D. The customer can connect to the network management Ethernet port which is pre-configured to use
the 192 168 1 1/24 IP address
Click the exhibit button. SLPP has just been enabled on both core switches.
Based on the network diagram and console output from the core 1 Ethernet Routing Switch (ERS)
B600 shown in the exhibit, what is the configuration error on the edge switch?
A. The edge switch spanning-trcc has not been configured.
B. The edge switch access port rate limiting has not been configured.
C. The edge MLT has not been configured correctly.
D. The edge VUXNs has not been configured.
A technician is configuring password levels on the Ethernet Routing Switch (ERS) 8600, and
wants the manager to be able to view and edit most device settings, but not be able to change
security and password settings. Which login Level should be set for the manager?
A. Layer 2 Read Write Access
C. Read Write All Access
D. Read-Write Access
Routed Split Multilinking Trunking (RSMLT) is a way to ensure that traffic can be routed off the
VLAN by adding router redundancy. RSMLT is configured on which Ethernet Routing Switch (ERS)
A. an OSPF router
B. a core switch port
C. a VLAN
D. an SMLT
A technician is configuring the core of a Converged Campus network, and is adding a backupmaster configuration to an existing Virtual Router Redundancy Protocol (VRRP) configuration for a
VLAN that extends to the edge switches.
Which benefit is expected from the Addition of backup-master?
A. reduced traffic on the IST
B. reduced traffic on the uplink ports
C. redundant default gateways for host devices
D. faster switchover time
In Ethernet Routing Switch (ERS) 5600 switch was added into the existing ERS 5500 stack, but ft
did not form a proper stack.
Which statement describes the problem?
A. The ERS 5600 was set as the Base Unit.
B. The stack was reset for a change in Base Unit to take effect.
C. The mode parameter on the ERS 5600 switch was set to Mixed Mode.
D. The ERS 5500 was set as the Base Unit.
…go to http://www.lead2pass.com/3600.html to download the lastest full version.
Why Choose Lead2pass?
If you want to pass the exam successfully in first attempt you have to choose the best IT study material provider, in my opinion, Lead2pass is one of the best way to prepare for the exam.
|One Time Purchase||✔||✖||✖||✖||✖|
|100% Pass Guarantee||✔||✖||✖||✖||✖|
|100% Money Back||✔||✖||✖||✖||✖|